Assembly instructions

Tenon Base Rail — Assembly instructions

Tools needed: drill, pencil, spirit level, screwdriver
Material needed: wall plugs suitable for your wall, countersunk screws with a head width of max. 4 mm (not included). The screw length depends on the plug you choose — follow the plug manufacturer's specifications.

Image step 1

1. Choose the position and check the wall

Choose the position you want for the base rail. Tap the wall at that spot to determine its structure (e.g. concrete, brick, plasterboard) — this decides which plug is suitable.

Image step 2

2. Mark the holes

Mark the position of the upper hole. Using a spirit level, measure 360 mm straight down (center to center) and mark the lower hole.

Image step 3

3. Drill and insert the plugs

Drill both holes and insert the matching plugs.

Image step 4

4. Fix the lower spacer

Screw the lower spacer to the wall with a countersunk screw (max. 4 mm head width, length to match the chosen plug).

Image step 5

5. Finish mounting the spacers

Screw the upper spacer to the wall with a suitable countersunk screw as well. For both spacers (top and bottom), place the plastic washer between the spacer and the base rail and screw the rail on with it.

Image step 6

6. Load test

Check the installation with a light load test before you use the system.

Safety note: Do not use Tenon if it has not been mounted correctly or the wall is not suitable. Maximum load: 1.5 kg.